Manual Tune - Inverto IDL 7000m TCI Manual Del Usuario

2.1.4 Hard disk Settings
Formatting the Hard disk: If you have to format your Hard
disk e.g. in case of a defective function, select activating
formatting. Warning: All stored data (recorded movies of
the library etc.) will get lost during formatting. Confirm the
desired function with the red (No) or the green (Yes) key.
2.1.5 Time/Date
General Settings: If the "Automatic Time Setup" (bottom
right) is set to "On", the receiver will receive the digital clock
time and date as broadcast by the digital TV programme
providers. The DVB standard will broadcast this in the GMT
time zone. In order to display local time correctly, it may be necessary to set a time offset, indicating the
difference between local time and GMT (e.g. in Germany daylight savings time in summer is + 2h, winter
time is + 1h).
Clock mode: The time can be displayed in 12 or 24 hour format.
Automatic Time Setup: The receiver can either receive the current time via the digital TV programmes
(On), or it can calculate current time independently (Off). In this case, the current time must be selected
under "General Settings". On this page use the "OK/Menu" key, then the time must be entered manually
by using the directional keys.
2.1.6 Programme Search
There are various ways of performing a programme search. Using the "OK/Menu" key, call up the Main
Menu, select the sub-menu "Installation/Set-up" followed by "Channel Search" using the directional keys
(and confirm each time by pressing the "OK/Menu" key). You can now choose between the various search
methods available.
2.1.6.1 Auto Tune
The Auto Tune scan function can be used to allow the receiver to search for new programmes. In this
case, the entire frequency range is scanned.
Then, it is necessary to choose between "Add new services" or "Replace existing services" options.
The "Add new services" deletes all the channels which were in the memory and scan. The option "Replace
existing services" scans and add the new channels to the existing list in the receiver.

2.1.6.2 Manual Tune

In case specific programmes cannot be found by means of the automatic search, e.g. because the
programme broadcasting format does not comply with DVB standards, you may employ a manual programme
search function.
In this on-screen display you will have to specifically input the broadcast channel/frequency, TX mode and
Guard interval if available (Auto mode field in mode No). If the TX mode and guard interval are not known,
it is possible to setup Auto mode to Yes.
Press the yellow key on the remote control to activate the search.