Nostalgia Products MSB1AQ Instrucciones Y Recetas página 9

11. Place Lid on unit and line up arrows on
Lid and Blending Chamber. This is a safety
feature and the unit will not turn on
without the Lid in the correct position.
12. You can add additional liquid at
any time by opening the Clear
Window in the Lid. Add more liquid after mixing to reach desired consistency.
13. Plug in unit and turn ON by flipping the switch downward to ON position.
OFF
14. Blend for approximately 10 minutes or until mixture has reached the desired consistency.
15. While the unit is still on, place glass underneath the Spout and dispense the beverage
by lifting the Spout handle up. It is recommended to place a towel or other cloth on the
table or countertop underneath the Spout to protect against any drips. NOTE: the Spout
has a locking upright position for filling multiple drink glasses or a pitcher of drinks.
16. If the Spout drips after dispensing, place a glass or container underneath Spout and open
and close the valve by pushing down on the Spout Handle once or twice quickly. Small
ice chips can sometimes get caught in the gasket, preventing it from closing completely.
17. Turn off the unit when desired consistency is achieved and it will
keep your beverage cold until ready to dispense again.
18. Always dispense beverage with the appliance turned ON. Allow the unit to
run for 8 seconds to mix before dispensing if unit has been sitting. When
you have finished, turn side knob to OFF position and unplug unit.
7
ON