C2G 50191 Guia De Inicio Rapido página 2

Installation Process:
Note: It is highly recommended that you read all owner's manuals and test all equipment
with the intended source and sink devices before permanently installing products.
1.
Remove power from all equipment involved in the installation process.
2.
Reference Installation Instructions, Steps 1-2, for Wiremold A/V Table Boxes –
C2G Integration Bracket. This step will require Phillips Screw Driver. Attach the
HDMI, VGA, and Audio to HDMI Converter Switch to the Wiremold A/V Table
Boxes – C2G Integration Bracket. Use the mounting screws included with the
HDMI, VGA, and Audio to HDMI Converter Switch.
Tech Tip: Remember to select "Auto" setting on function slide switch on the
HDMI, VGA, and Audio to HDMI Converter Switch before installation.
3.
Reference Installation Instructions, Steps 1-2, for Wiremold A/V Table Boxes –
C2G Integration Bracket. Attach the Wireless A/V System TX to the HDMI, VGA,
and Audio to HDMI Converter Switch/Wiremold A/V Table Boxes – C2G
Integration Bracket. Use the hook and loop pads included in the Wireless A/V
system.
4.
Reference Installation Instructions, Steps 3-4, for Wiremold A/V Table Boxes –
C2G Integration Bracket. Attach the Wiremold A/V Table Boxes – C2G
Integration Bracket to the Wiremold InteGreat A/V Table Box, by sliding the
mounting hooks of the bracket into the side of the table box with 4 cut outs.
Finish mounting by inserting the included rivets.
Tech Tip: The Wiremold A/V Table Boxes – C2G Integration Bracket has
opening where you can attach cables for proper strain relief.
5.
Reference Installation Instructions, Step 6a, for Wiremold A/V Table Boxes. This
step will require 3/32" Allen Wrench. Feed the 6ft Ultra Flexible High Speed
HDMI Cable, the 6ft VGA Monitor Cable and the 6ft 3.5mm Stereo Audio Cable
through the opening of the device plate (opening with ten screw holes). Place
Cable Kit plates around each cable and attach to device plate using (2) #4-40
screws in each plate. Attach remaining Cable Kit plates to device plate. Place
grommets around the cables and snap into hole in Cable Kit plate. Snap
remaining grommets into the empty holes.
Tech Tip: Placing the HDMI cable through the grommet opening closest to the
front edge (handle side) will allow a smoother feed of the cable.
6.
Reference Installation Instructions, Step 2, for Wiremold A/V Table Boxes. This
step will require Phillips Screw Driver. Install device plate into A/V Table Box
using (4) #8-32 screws. Select the device plate level (refer to illustrations with
Tables 2A and 2B in the Wiremold A/V Table Boxes Installation Instructions).
The device plate should be installed at deeper settings to accommodate
cable bend radius and allow the cover to close while the box is activated.
loading