Setting Date/Time; Memory Button - smartheart 01-571 Manual De Instrucciones

SETTING DATE/TIME

IT IS NECESSARY TO SET THE DATE AND TIME FOR THE
UNIT EVERY TIME BATTERIES ARE INITIALLY INSTALLED OR
REPLACED
The date/time feature is on the bottom left of the display screen. This unit stores the
date and time, including year allowing for a date/time stamp on all readings in
the memory recall function.
1. When the batteries are first installed, the device will automatically prompt you to set the
Date/Time feature.*
*NOTE: If the batteries have already been installed—when the unit is off (a blank
display screen), press and hold the S (SET) button for 3-5 seconds to make the unit go
into clock setting mode.
YEAR—next the year will flash on the display. Press the M button to advance the display
2.
to the desired year, press the S button to confirm your selection and advance to the date
settings.
MONTH/DATE—repeat the same sequence of step 2 to confirm the MONTH and DATE
3.
setting.
HOURS/MINUTES—repeat the same sequence of step 2 to confirm the HOUR and
4.
MINUTE setting.
5. After the Date/Time setting function is complete, the monitor is ready for use.
10 • ENGLISH
The User, Memory, Set and Start•Stop buttons
are located on the right side of the display.
USER button

MEMORY button

SET button
START•STOP button