Tabla de contenido
Step 10
Separate the NARROW EXTENSION SLIDES (KK2) from the NARROW EXTENSION RAILS (JJ2) as shown in the upper
å
diagram below. Be prepared, the parts are greasy.
Fasten the NARROW EXTENSION RAILS (JJ2) to the ENDS (A and B) and UPRIGHTS (C3 and D3). Use eight GOLD 5/16"
å
FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END and UPRIGHT. Turn a
SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
JJ2
Open end
www.sauder.com/services
KK2
Push the black lever in and pull the SLIDE from the RAIL.
C3
JJ2
Open end
JJ2
Open end
JJ2
A
B
408920
3S
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
Open end
JJ2
D3
Page 15
Tabla de contenido
