Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Wall Sleeve Brands:
#8 White Westinghouse/Frigidaire/
Carrier 52F Series ( 16 +17 Deep)
1. If the wall sleeve does not have a rear grille or
louvered panel, install the plastic grille from
the kit. The plastic grille is mounted to the
inside of the wall sleeve at the rear flanges.
There are (4) plastic nuts in the flanges of the
wall sleeve. If some are missing replacements
are included in the accessory kit, and can be
simply pressed into the square holes in the
flanges. Place the grille against the rear flanges
and use the (4) large washers and screws to
secure the grille.
1
/
2. Attach (1)1
x3/8 x25 long seal in the center
2
at the top of the sleeve. Remove the backing
paper and press into position.
3. Attach (2) 1
1
x3/8 x14 seals to the left and
/
2
right sides of the sleeve.
4. Cut the 1 x3/4 x14 long seal vertically 7
from the left side of the sleeve.
5. Center unit and gently slide unit into sleeve.
6. Before sliding all-the-way back, remove 2nd
screw from front on left side of unit.
7. Remove the plastic washer from the screw.
8. Screw and attach the other end of the ground
wire to the unit as shown in picture. Make sure
that the toothed washer is against the cabinet.
9. Slide the unit completely to the rear to ensure
a good seal, making sure the ground wire does
not become tangled.
10.Seal & Frame the unit as described on the last
page of these instructions.
19
1
/
2
Tabla de contenido
