Opening And Closing The Housing; Tools Required; Figure 4 Locations Of Housing Screws - Federal Signal eSiren Instrucciones De Instalación Y Servicio

Opening and Closing the Housing

HOUSING DAMAGE: Use caution and support the housing when
loosening the cover screws. The housing is not supported by any means
other than the cover screws. Once they are loosened, the housing will
separate from the cover.
Depending upon the model, the factory‑supplied leads are strain‑
relieved to the housing or to the cover.
Opening the Housing

Tools required:

3/8 in socket
6 in extension
See Figure 4. Loosen the four cover screws while supporting
the housing so it does not fall. (The cover screws are retained in
the housing).
Closing the Housing
1. Verify that the cover gasket is in the groove around the
perimeter of the cover.
2. Align the housing with the cover. Note that the
the front of the eSiren needs to be oriented correctly with
Installation and Maintenance Instructions

Figure 4 Locations of housing screws

Cover Screws (4 Places)
Model eSiren
logo on
FS
11