1.- IMPORTANT INFORMATION
Please read these
instructions before installing or
using this appliance for the first
time.
This appliance is only
intended for household use.
The installation must be
carried out in accordance with
the current local electrical
regulations. Any installation or
reinstallation has to be carried
out by an experienced
technician.
Dielectric bushingsmust be
fitted to the water inflow and
outlet pipes. The warranty will
not cover damage caused by
them not being fitted.
The use of this water heater
is forbidden in areas where
there are explosive gases or
flammable substances.
Please check that the
voltage in the rating label fits
the power supply.
This appliance must be
grounded.
Keep the supply cable away
from the hot parts of the water
heater.
Improper handling of the
appliance may result in serious
injury.
Do not pull on the cable but
on the plug to disconnect the
water heater from a socket.
Do not use extension
leads.They can result in
overheating and cause a fire.
Never touch the immersion
heater when bare-footed or if
your hands are wet or damp.
The water heater must be
unplugged when it is installed
and being cleaned.
The appliance should not
be installed just below an
electrical receptacle.
The appliance must be
installed in such a way that it is
impossible for anyone using a
bath or shower, to touch the
controls.
Keep combustible
materials, such as furniture,
pillows, bedding, papers,
clothes, etc. and curtains at
least 80cm from the front, sides
and rear of the water heater.
Never dismantle the
immersion heater components
or replace them with others that
do not meet the safety
requirements.If the power cable
is damaged, it must be
replaced by the manufacturer
or by its official agent to avoid
any hazard.