ASROCK 775XFire-VSTA Manual De Instrucciones página 22

2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors
2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 22)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 9)
connect the blue end
to the motherboard
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAI Connectors
(SATA_0: see p.2, No. 15)
(SATA_1: see p.2, No. 14)
(SATA_2: see p.2, No. 12)
(SATA_3: see p.2, No. 13)
Serial ATA (SATA)
Data Cable
(Optional)
2 2 2 2 2 2
2 2 2 2
80-conductor ATA 66/100 cable
ASRock 775XFire-VSTA Motherboard
the red-striped side to Pin1
connect the black end
to the IDE devices
These four Serial ATA
(SATA) connectors support
SATA data cables for internal
storage devices. The current
SATA interface allows up to
1.5 Gb/s data transfer rate.
Either end of the SATA data cable
can be connected to the SATA
hard disk or the SATA connector
on the motherboard.