Estar HUBBLE-11 Manual De Usuario página 4

REMOTE CONTROL UNIT BATTERY INSTALLATION (2)
EN
Put inside 3 AAA type batteries, following the + and – polarity signs as marked
In the battery place and pictures
WARNING! Install the batteries with correct polarity
DO NOT mix old and new batteries
DO NOT mix different types of the batteries
RECHARGING OF LITIUM POLYMER BATTERY (3)
USB charger should support the current not less than 0,5A. The charging time may take up to 60 mins.
PREPARATION FOR THE FLIGHT
BINDING OF RADIO TRANSMITTER AND RECEIVER (4)
Step 1 (5): Install the battery in the drone's battery compartment, as shown on picture.
Connect the battery cable to the drone power cable with black/red connector.
Place the drone on the flat surface. Turn on the power switch on the drone.
The lights of the drone will start flashing.
Step 2. (6): Lower the throttle stick to the lowest position, then turn on the remote controller.
Turn the throttle stick shortly up/down.
Wait until the RCU indicator and the drone lights stop flashing, then the drone is ready to fly.
Step 3. (7): When flying is finished, turn off the drone power switch. It is also recommended to disconnect
The battery power cable when not in use for a longer period to have a longer battery life.
Step 4. Turn off the RCU power. (8): If the drone is not used for the longer period, it is recommended to remove
the batteries from RCU.
Please use 3 AAA type batteries (not included)
Step 1:
Open the battery cover on the back of the RCU
Step 2:
Please read the safety notes for the battery first!
Please connect the USB charger cable to the battery charging port.
Further the USB charger should be connected to the USB port of the computer or
AC USB charger. When the red LED is on - the battery is charging. When red LED
is blinking or turned OFF – the battery is fully charged. Please note the USB port or