Before You Begin; Package Contents; Hardware Overview; Hardware Installation - D-Link DSS-100E-9P Guia De Instalacion

Before You Begin

This Quick Installation Guide gives you step-by-step
instructions for setting up your DSS-100E-9P 9-port
10/100 PoE Surveillance Switch. The model you have
purchased may appear slightly different from the
one shown in the illustrations.

Package Contents

This DSS-100E-9P package should include the
following items:
• 1 x DSS-100E-9P
• 1 x Power cord
• 1 x Power adaptor
• 1 x Quick Installation Guide
If any of the above items are damaged or missing,
please contact your local D-Link reseller.

Hardware Overview

LED Indicators
1
Figure 1: Front panel LEDs
# LED Status
Solid
green
1 Power
Off
Solid
Link/
green
ACT/
Speed
2 Blinking
(Left
green
Led)
Off
Solid
green
Blinking
PoE green
(Right
3
Led)
Off
Table 1: LED overview
2
2 3
Description
The switch is powered on.
The switch is turned off.
There is an active link negotiated
on this port.
There is traffic on the port.
There is no active link on this port.
The port is providing power to the
connected PoE-powered device.
Indicates a PoE-powered device
is connected to this PoE port,
but the switch has insufficient
remaining power budget to
power the device.
There is no PoE-powered device
connected to this port.
Front Panel Connectors
Figure 2: Front panel connectors
# Interface
10/100 Mbps PoE-capable ports,
1 Ports 1 - 8 used for connecting Ethernet
devices and PoE-powered devices.
10/100/1000 Mbps Ethernet
2 Ports 9 port for uplink connections to
NVR, storage or core switch.
Table 2: Front connector description
Rear Panel Connectors
Figure 3: Rear panel connectors
# Connector
1 DC Power Input Input jack for the power adapter.
Screw used to secure a grounding
SWITCH GND
2
wire to connect the switch to ground.
Table 3: Rear connector description
Extended Mode
The DSS-100E-9P can automatically detect the long
reach requirement and activate Extended without
manual configuration.
P.S. The actual transmission distance will be affected
by cable quality or connected IP Camera design. The
device can support up to 250m application with
Cat5e above ethernet cable, but the transmission
may drop to 10Mbps speed or below.

Hardware Installation

Installation Precautions

For safe switch installation and operation, it is
recommended to:
1 2
Description
1 2
Description
DSS-100E-9P