Quick Clear Valve - Mosquito Magnet Commander Manual De Operación

Easy Quick Clear Valve
Important: Extinguish all smoking materials prior to use of
Easy Quick Clear Valve. Do not stand directly behind the
Quick Clear cartridge during operation.
Use of PROTECTIVE eyewear is recommended.
Important: Shut down your trap. Let fan run until it
stops before using Quick Clear Cartridges (about 5
minutes).
Quick Clear is recommended for regular maintenance to remove
built-up contaminants.
Recommended for use at every tank change. Also recommended for
use before seasonal storage to avoid build up of contaminants during the
off-season. Instructions for "Easy Quick Clear Valve" maintenance
procedure shall be provided on a label attached to trap where easily
visible by user.
The Easy Quick Clear Valve is a threaded knob located on the back of
your trap. It should be used with the adapter included with your trap,
and a threaded Quick Clear cartridge available on our website at:
www.mosquitomagnet.com or at your local hardware or home
improvement store.
1. Important: Shut down your trap. Let fan run until it
stops before using Quick Clear Cartridges (about 5 minutes).
2. Close the propane tank valve by turning to the "OFF" position. (Turn
the tank valve clockwise.)
3. Remove the protective cap from Easy Quick Clear valve located
in the back of the trap.
4. Hand-screw the Quick Clear adapter on to Quick Clear valve, until
finger tight.
5. Hand-screw the Quick Clear cartridge into the Quick Clear
adapter clockwise until hand tight while holding the adapter in
place. Important: Do not over-tighten.
6. While holding the adapter in place slowly unscrew
Quick Clear cartridge up to 1/4 turn only in counter clockwise
direction from the Quick Clear adapter only. The strong flow of
compressed air lasts approximately 45 seconds. Be sure to allow
Quick Clear cartridge to run out completely. (Hissing will stop when
cylinder is empty. Quick Clear cartridge will be cold to the touch.)
7. Unscrew the Quick Clear cartridge to remove. Discard empty Quick Clear
cartridge after use, it is not reusable or refillable.
8. Unscrew the Quick Clear adapter to remove.
Use caution when removing Quick Clear adapter and cartridge, as
some compressed air may come out at this time.
Remember to keep the Quick Clear adapter for future use.
9. Replace Easy Quick Clear Valve protective cap, and proceed
with normal start up of your trap. If use of Easy Quick Clear valve
feature does not resolve starting trouble, contact Customer Care
1-800-953-5737.
13
Step 4
First hand-screw the Quick Clear adapter onto the valve.
Step 5
While holding the adapter in place, screw the Quick Clear
cartridge into Quick Clear adapter.
Step 6
To start cleaning process, while holding Quick Clear
Adapter in place, unscrew the Quick Clear cartridge
1/4 Turn Only.
Step 7
Unscrew the Quick Clear cartridge first, then unscrew Quick
Clear adapter and discard the spent Quick Clear cartridge.
Remember to keep the Quick Clear adapter for future use.