Removing The Belt Clip; Installing The Belt Clip; Installing The Batteries - BRONDI FX-400 Twin Manual De Instruccion

2. Installation

2.1 Removing the Belt Clip

a. Pull the Belt Clip latch forward(away from the
FX-400)
b. While pulling the Belt Clip latch, push up the
Belt Clip as shown in Figure1.

2.2 Installing the Belt Clip

a. Slide the Belt Clip into the slot as shown in
Figure2.
b. A "click" indicates the Belt Clip is locked into
position.
2.3

Installing the Batteries

Caution: Observe the proper battery polarity orientation when installing batteries. Incorrect
positioning can damage both the batteries and the unit.
a. Pull up the battery cover latch, Lift up Battery Compartment Cover.
b. Install the rechargeable batteries by following the orientation as shown in Figure 3 (the
arrow is showing and pointing upward.)
c. Replace the Battery Compartment Cover. See Figure 4.
Read these Safety Warnings before you charge the batteries.
When placing the FX-400 in the charger, use only the rechargeable batteries supplied
with the FX-400.
Don't try to recharge non-rechargeable batteries.
Make sure the battery compartment cover is securely locked in place when you are
charging the batteries.
Dispose of used batteries safely and in a way that will not harm the environment- never
try to burn them or put them anywhere, they could get burnt or punctured.
Don't leave dead batteries in your FX-400 units.
They might leak if you do.
Figure 3
Important
- 3 -
Belt Clip latch
Figure 1
Figure 2
Figure 4