HP 10/100 3Com 3C905B-TX Guia De Instalacion página 18

HP 10/100 3Com 3C905B-TX Network Interface Card Installation Guide
Troubleshooting
Troubleshooting
The 3C905B-TX Card Does Not Work
If your network interface does not work, try the following:
Check that:
•
The card is correctly installed (refer to "Installing the Network
•
Interface Card" on page 7).
The LAN-specific fields in the HP PC Setup utility are correctly
•
set (refer to "Updating LAN-specific Fields in the HP PC Setup
Utility" on page 9).
The software installation steps have been followed (refer to
•
"Software Installation Procedure" on page 10).
Check the network cables. In particular, check that the network
•
cable connections are secure and that the cables are not damaged. If
you find any loose connections or damaged cables, fix them and then
see if your PC can communicate on the network.
Check that either the 10 LNK or 100LNK green LED on the
•
3C905B-TX NIC's rear panel is on (refer to "3C905B-TX NIC
Specifications" on page 16). The green LED on the card's rear panel
is off when there is no network link, for example, when the LAN
cable is not connected to the network HUB.
For NT 4.0 systems, check that your Service Pack has been
•
reinstalled. In case of doubt, reinstall the Service Pack.
14 English