AUX ALCA-HA 18K Manual De Instalación Y Usuario página 78

Place the indoor unit at a distance of at least 1 meter from televisions, radios and
-
general electrical equipment whose electromagnetic waves may directly influence
the electrical box or remote control.
- Pay particular attention to the installation warnings and conditions of use if the
indoor units are located in hospitals, near medical equipment or generally in places
with significant electromagnetic waves.
lf the indoor units are installed in areas exposed to high concentrations of magnetic
-
interference, you must use shielded twisted cables far communication links between
units.
- Do not install in laundries.
This type of indoor unit does not use an electric heater. You cannot install an electric
-
heater or an electric stove at the installation site.
Install the indoor unit on a solid surface that can support the weight of the air
-
conditioner. Make sure that the support is securely installed and the unit is stable
even after running for an extended period. lf not properly secured, the unit may fall
and cause damage or injury to objects and persons.
- Do not place objects of any kind inside the indoor unit. Remember to check that
there are no foreign objects inside the unit before installation and testing.
- Far the outdoor unit, choose an installation location where the noise and the air jet
do not disturb neighbors.
- Avoid placing the outdoor unit in a location where it causes an obstacle to
pedestrians.
- Position the outdoor unit in line with local architectural rules.
Respect the dimensions given in the manual, the lengths of the refrigerant lines and
-
the height difference between units.
Ensure that the appliances are not accessible by disabled persons and children. Do
-
not block the entrances to the air inlets and outlets. Doing so will significantly reduce
the heating and cooling capacity.
Do not place objects on the outdoor unit or climb over it. Perform a test after carrying
-
out wiring.
Wiring diagrams are subject to ongoing updates. lt is therefore compulsory to refer to
-
those on the machine itself.
Before turning on the air conditioner, make sure that the electrical cables,
-
condensation drainage pipes and refrigerant connections are properly configured
and installed. This eliminates the risk of water or refrigerant gas leaks or electric
shocks.
Periodically check the conditions of installation of the unit. Have the system checked
-
by qualified personnel.
After switching on the air conditioner, do not switch it off for at least 5 minutes. This
-
prevents oil from returning to the compressor.
Do not disassemble are repair the unit while it is running.
-
78