Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6-7
WARNING!
Technical data
4.2
Temperature range:
Tool cable:
Heating output:
Voltage (heater):
Heating-up time:
Connection:
Dimensions:
Soldering bath
5 Commissioning the device
Risk of burns
The soldering tips of soldering irons become very hot during
soldering and desoldering processes.
There is a risk of burns from touching the tips.
Do not touch the hot soldering tips and keep them away from
inflammable objects.
1. Make sure that there are no flammable or heat sensitive objects
in the vicinity of the solder bath.
2. Insert the connecting plug into the socket on the power supply
unit and lock the plug into the socket by turning it clockwise.
3. Turn on the supply unit.
4. Set the desired temperature at the supply unit (100°C - 500°C).
You can begin soldering work after the required heating-up time
has expired.
6 Equipotential bonding
The solder bath is connected to the supply unit by an equipotential
bonding conductor. There are various possibilities for potential
equalisation. The procedure for potential equalisation is described in
the Operating Instructions for the supply unit in use.
7 Disposal
Dispose of replaced equipment parts, filters or old devices in
accordance with the rules and regulations applicable in your country.
8 Warranty
Claims by the buyer for physical defects are time-barred after a
period of one year from delivery to the buyer. This does not apply to
claims by the buyer for indemnification in accordance with §§ 478,
479 BGB (German Federal Law Gazette).
We shall only be liable for claims arising from a warranty furnished
by us if the quality or durability warranty has been furnished by use
in writing and using the term "Warranty".
100°C - 500°C (212°F - 932°F)
Silicone rubber, heat resistant
200 W
24 V
approx. 11 min (100°C to 350°C)
(212°F to 662°F)
12 pin connector, polarity protected with
lock
L x W x H (mm) 150 x 120 x 65
L x W x H (mm) 58 x 30 x 19
WXSB 200
Capítulos
Tabla de contenido
