Solo 550 Manual De Funcionamiento página 26

We ask you to accept, that losses due to the following causes fall outside our warranty:
• Contravening the operating instructions. • Missing essential maintenance and cleaning work. • Losses as a result of
incorrect carburettor adjustment. • Wear as a result of normal use. • Obvious overloading through sustained ex-
ceeding of the upper output limit. • Use of unauthorised tools/accessories. • Application of force, incorrect treat-
ment, misuse or accident. • Damage as a result of overheating due to contamination of the fan housing. • Interven-
tion by untrained individuals or incorrect attempts at repair. • Use of unsuitable materials or non-original parts, if
these have been responsible for the loss. • Use of unsuitable or superimposed consumables. • Losses caused by the
conditions of use in a rental business.
Cleaning, care and adjustments are not recognised warranty work.
All warranty work must be carried out by a specialist authorised by the manufacturer.
Faults
Rough running,
strong machine vibrations
Engine will not start
The engine runs rough
The starter cord snatches back
The lawn turns yellow,
unclean cut
The mower collects poorly
Self-drive does not work
Self-drive mower cannot be
pulled backwards
Possible Cause
- Fasteners on the engine, its own
mountings or on the mower
chassis are loose
- Cutting blade fasteners loose
- Blade out of balance or damaged
- Friction clutch faulty
- Is the brake bar pressed against
the handle?
- Is the throttle control correctly
positioned?
- Is the Bowden cable/engine brake
in the correct position?
- Spark plug or spark plug cap faulty
- Fuel tank empty
- Air filter contaminated
- Throttle Bowden cable kinked
- Spark plug sooty
- Blade fastener or friction clutch loose
- Blade blunt
- Cutting height too low
- Engine speed too low
- Engine speed too low
- Cutting height too low for tall grass
- Blade worn
- Grass catcher bag clogged up
- Control bar not pulled back
- Bowden cable kinked or incorrectly
adjusted
- Drive belt too slack
- Control bar not released
- Bowden cable kinked or incorrectly
adjusted
- Interior of drive wheels contaminated or
not lubricated
Remedy
- Retighten screws
- Check blade fasteners
- Balance or replace cutting blade
- Possibly replace friction washers (in pairs)
- Press brake bar
- Select correct adjustment
- Check for correct adjustment
- Clean or replace spark plug
- Fill fuel tank
- Clean or replace air filter
- Adjust or replace throttle Bowden cable
- Clean spark plug
- Check blade fasteners
- Sharpen the cutting blade
- Correct height adjustment
- Move throttle control to max.
- Move throttle control to max.
- Correct height adjustment
- Replace the cutting blade
- Clean or replace the grass catcher bag
- Pull the control bar towards the handle
- Adjust the Bowden cable
- Retighten the drive belt
- Release the control bar
- Adjust the Bowden cable
- Clean and lubricate the wheels