Light Switch - Holmatro CT 5111 Manual De Instrucciones

EN
• Remove dirt and oil from the couplers and dust caps.
• Replace the dust caps on the female and male couplers.
5.5 Relief the pressure in unconnected hoses and tools
5.5.1 General
Temperature differences can cause overpressure in unconnected hoses and tools. This overpressure
can make it impossible to connect the parts. You can use the pressure relief tool to remove this
overpressure. This accessory is available for all Holmatro hose systems and is supplied by default with
every pump.
NOTICE
We recommend you keep more than one of these tools on hand.
5.5.2 Hose with CORE™ couplers
Refer to Fig. 7.
• Hook the pressure relief tool over the male coupler (1).
• Turn the knob clockwise (2) to release the pressure. Some oil will be released.
• Turn the knob counterclockwise (3).
• Remove the pressure relief tool from the coupler (4).
5.6 Operate the deadman's handle
The deadman's handle is used to determine the movement of the plunger(s). In the neutral position no
pressure is built up and the oil flows back to the pump without pressure. If the deadman's handle is
released, it returns automatically to the neutral position and stops the movement of the plunger(s).
/i
Hold the deadman's handle in this position to open the tool/blades. Pressure is built
up in the tool. Return oil from the tool flows back to the pump without pressure.
Hold the deadman's handle in this position to close the tool/blades. Pressure is built
up in the tool. Return oil from the tool flows back to the pump without pressure.
5.7

Light switch

Refer to Fig. 2.
On the carrying handle there is a switch for the integrated LED lights (not for ST or RH model).
• Press the switch to turn the light on and off.
• The battery should be replaced when the lights no longer turn on if the switch is pressed.
40 916.001.554_004 CT51** (RH)(ST)