Checking For Leaks - 3 Embers GAS7480AS Instrucciones Para El Montaje Y Uso

CHECKING FOR LEAKS:

1. Create a mixture of 50% water and 50% liquid dishwashing soap.
2. Open the lid.
3. Ensure all control knobs are set to the "OFF" position.
4. Ensure gas hose is tightly connected to gas source.
5. Turn on the fuel supply at the source.
6. Apply the soap water mixture to the following:
Hose connection to gas manifold.
A
Brass connections and quick
B
disconnect assembly.
The full length of gas supply hose.
C
Quick disconnect coupler.
D
7. Check each place listed (A– D) for growing bubbles
which indicates a leak.
8. Turn off gas supply at source.
9. Turn on control knobs to release gas pressure in hose.
10. Turn control knobs to "OFF" position.
11. Tighten any leaking connections.
12. Repeat soapy water test until no leaks are detected.
13. Turn off gas supply at source until you are ready to use your grill.
14. Wash off soapy residue with cold water and towel dry.
15. Wait 5 minutes to allow all gas to evacuate the area before lighting grill.
CAUTION: DO NOT use the grill if leaks cannot be stopped.
Note: The leak test must be performed in an area that has adequate lighting in order
to see if bubbles are developing.
Watch For Bub bles
A
C
D
B
10