MID WEST FERRET NATION 183 Instrucciones De Armado

Assembly Instructions for Model Number 183
ImPortant InformatIon
Unwrap and remove all parts from the box. Keep the box and packing material until the product is assembled. In case of return
or exchange, failure to return product in similar condition as received could result in limited reimbursement. Please save sales
receipt as proof of purchase for warranty purposes. Check to ensure you have all the parts below. If you discover any parts are
missing, immediately call our toll-free service helpline at 1-800-428-8560 (Monday - Friday 9 a.m. to 4 p.m. EST) or at
[email protected]. To protect the finish of your Pet Home and the bottom pan, use only mild, non-abrasive cleaners
and water. Any course scrubbing or abrasive materials could damage the finish.
Note: Although it can be assembled by one person, due to the size, you may find it easier to assemble Ferret Nation with two
able people. While no tools will be required, you may also find a rubber mallet helpful while connecting the pieces together.
The Instruction Manual that came with the Model 161, 162, 181, or 182 might be good for reference while assembling the
add-on unit. These Instruction Manuals can be downloaded at www.midwesthomes4pets.com.
The Top Panel from the assembled cage will be removed and used as the top to the add-on unit. The included Middle Grid
Panel (D) will be put in place of the existing Top Panel.
If you are adding onto a fully assembled Model 161, 162, 181, or 182, you will need to disassemble a small part of the cage.
If you are adding this unit while you are assembling a Model 161, 162, 181, or 182, skip to Step 2.
Parts IdentIfIcatIon
A - Door Panel -
Large rectangular panel with (1) doors
and latch knobs.
B - Back Panel -
Large rectangular panel without doors.
C - Side Panel (2) -
Smaller rectangular panel with protruding
---- locking tabs at the top and hole for Swivel Lock (0)
D - Middle Floor Panel Grid -
with cut out
E - Middle Pan -
Plastic tray with cut out that fits in the middle of
the cage.
F - Shelf - Wire Structure with plastic shelf pan.
G - Ramp (2), Clips (2), and Covers (2) -
access from one level to the other. (Note: There is a slight bend
in the middle, this is intentional.) Clips attach Ramp to Shelf and
reversible Covers slip over the ramp.
H Flat Head Screws (2)
-
I - Swivel Locks (2)
J - Phillips Head Screwdriver
Large rectangular mesh panel
Wire ramp for
H
J
800-428-8560
midwesthomes4pets.com
P .O. Box 1031
Muncie, Indiana 47308
A
D
F
I
B
E
G
Ramp Clips
Ramp, with Cover,
Shown in Cage
C