Polk DXi Serie Manual De Instrucciones página 9

Tabla de contenido
With the coils wired in series and the
speakers wired in parallel
Trois haut-parleurs, à bobines jumelées
configurées en série, câblés en parallèle
Con las bobinas en serie y los altavoces
en paralelo
Schwingspulen in reihe geschalteten und
parallel geschalteten lautsprechern
Con le bobine in serie e i diffusori in parallelo
Com as bobinas ligadas em série e os
alto-falantes ligados em paralelo
wiring diagram for DXi 1201
Please make certain that your amplifier is rated to carry the specified load.
Assurez-vous que votre amplificateur peut soutenir les charges spécifiées.
Asegúrese de que el amplificador tenga la clasificación nominal necesaria
para llevar la carga especificada.
Vergewissern Sie sich, dass Ihr Verstärker die angegebenen Werte erfüllt.
Accertarsi che i valori nominali dell'amplificatore siano adeguati al
carico specificato.
O amplificador deve ter capacidade para suportar a carga especificada.
14
DXi: high performance car speakers
wiring diagram for DXi 1201
schema de cablage DXi 1201
diagramas de cableado para
el modelo DXi 1201
schaltplane fur DXi 1201
cablaggio per i modelli DXi 1201
esquemas de ligaçao para as
unidades DXi 1201
english
preconditioning period
DXi Subwoofers will achieve even greater performance once they are thoroughly broken
in. To break in your new DXi Subwoofer, play 20 to 30 hours of music at moderate levels.
get more information online at polk university
www.polkaudio.com
optimal crossover setting
We recommend using an active crossover with a 12 to 18dB per octave low
pass filter slope, and setting it to an initial setting of 80 to 90Hz as a good
starting point. This is an optimal crossover setting on most vehicles.
inverting phase
Depending on the placement of your subwoofer enclosure and associated
components, it may be necessary to invert the phase of one or another of your
system's connections in order to gain better subwoofer/mid-range blending.
Inverting the phase simply means switching the positive connections with the
negative connections at the amplifier. If you choose to do this, invert the phase
of only one set of speakers (either your mains, or your subs, never both).
low frequency cut-off for mid-range
speakers in systems with subwoofers
Now that you have a subwoofer in your system, you may want to decrease
the amount of bass going to your midrange speakers. This will get you better
mid-range sound and increase the power handling. There are two ways to roll
off the bass before it gets to your mid-range speakers. One way is to use
a "bass blocker," a capacitor placed in series with the speaker input. Bass
blockers are installed in series, one end connected with the positive lead from
your amplifier and the other end connected to the positive lead of each of your
speakers. Bass blocker capacitors (200 microfarad @ 100V, non-polarized) are
available at any Radio Shack or electronic parts supply house. The other route
is to use an electronic crossover device that allows filtering below 100Hz or so.
Find these devices at your authorized Polk dealer.
more information @ www.polkaudio.com
:
15
Tabla de contenido
loading

Este manual también es adecuado para:

Dxi1240dvcDxi1201

Tabla de contenido