Laws, Technical Rules And Norms; Safety; Electric Connection; Equipotential - Multi SCCP-72EM Guia Para La Intalación E Instrucciones De Uso

Installation must be carried out observing the following norms:
- Safety prescription in force
- Installation prescription, norms in force.
The equipment is intended only for the use for which it was designed; any other use is considered improper.
The manufacturer declines all responsibility for any damage or injury caused by improper or wrong use.
All maintenance operations that require precise technical skills or abilities, may only be performed by qualified
personnel.
To ensure the hygiene and protect food from contamination, it is necessary to thoroughly clean the elements that come
into direct or indirect contact with the food and all surrounding areas. Perform these operations using only cleaning
products suitable for food, avoiding flammable products or products that contain substances harmful to health.
After each use, make sure that the elements are switched off, with the control knobs off, and disconnect the power
supply lines.
The appliance is supplied without the connection cable. To install the power supply cable, proceed as follows:
•
Disconnect the power supply.
•
Remove the bottom panel
•
Push the connection cable through the cable blocker, connect the conductor wires to the corresponding terminals in
the junction box and fix them into place.
•
Block the cable with the cable blocker, and reassemble the bottom panel. The earth wire must be longer than the
others so that if the cable blocker should break, it will disconnect after the tension wires.
The connection must be carried out by authorized and qualified personnel, in accordance with applicable laws and with
the use of proper and prescribed material.
This equipment is supplied with 230Vac 50/60Hz operating voltage.
Before making the connection, make sure of the presence, in the power network, upstream of the appliance, of a
dedicated multipole switch with a minimum contact opening of 3 mm.
The appliance must be connected to an equipotential system. The connection screw is positioned at the back of the
appliance and is identified by the
Attention! The manufacturer will neither be held responsible for, nor will give any compensation during the guarantee
period for any damage caused, and which is due to inadequate installations not compliant with the instructions.
GB

LAWS, TECHNICAL RULES AND NORMS

SAFETY

ELECTRIC CONNECTION

EQUIPOTENTIAL

symbol.
IE
26