Cree WS Serie Instrucciones De Instalación

IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l'alimentation avant
l'installation.
2. This luminaire must be installed in accordance with the NEC or
your local electrical code. If you are not familiar with these codes
and requirements, consult a qualified electrician.
Ce produit doit être installé conformément à NEC ou votre code
électrique local. Si vous n'êtes pas familier avec ces codes et ces
exigences, veuillez contacter un électricien qualifié.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
TO INSTALL:
1
Mounting Holes Bosses
2
Conduit Hole
LED Tray
Lens Cover
1 of 2
NOTES:
• Liquid tight conduit fitting must be IP65 rated,
supplied by customer, to be used when attaching
conduit to housing.
DIRECT MOUNT
NOTE: For ceiling and wall mounting applications.
STEP 1:
Remove lens cover by unhinging the latches and set
cover aside to reinstall later.
STEP 2:
Loosen (2) screws and carefully let the LED Tray hang
down from hinges. See Figure 6.
STEP 3:
Using a Ø.203 max size drill bit, drill (4) mounting holes
for customer supplied hardware into the center of the
(4) bosses.
STEP 4:
Apply a 1/4" bead of customer supplied silicone to the
exterior around all (4) mounting holes on the housing.
STEP 5:
Attach housing to mounting surface using (4) customer
supplied #10 size minimum screws. See Figure 1.
NOTE: Mount the luminaire with the LED Tray facing
downward. See Figure 1.
Plug
STEP 6:
Insert customer supplied liquid tight conduit and liquid
tight conduit fitting into desired conduit hole located on
the end of the housing. The dimension of the conduit
hole on the housing is 3/4" IP. Bring in customer
supplied cord and make wiring connections per
"Electrical Connection" section. See Figure 2.
NOTE: Insert supplied plug into unused conduit hole.
STEP 7:
Bring LED Tray back into housing and secure by
tightening screws that were loosened in Step 2.
STEP 8:
Reattach lens cover removed in Step 1 and secure
using latches.
WS Series
LED Linear Luminaire
Direct Mount
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION
LPN00205X0001A1_A