Turbosaver TS-2200 Manual De Usuario página 24

Envasadora
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

seal gasket of the canister cover;
3.
Insert one end of the hose into the air intake and another end of the hose into the
center hole of the canister cover.
4.
Press the canister button to start vacuuming. To ensure there is no air leaking between
the cover and the canister, use your hand to push down the cover at the beginning of the
vacuuming work. The machine will stop automatically when enough vacuum pressure is
achieved.
5.
Take out the hose tube from the canister or bowl immediately first after the job is
completed.
NOTE: When moist food are under vacuuming, moisture will be stored in adaptor. Re-
member to clean up the adaptor if there is water before vacumming.
Open Canister After Vacuum Packaging
In order to open the canister, you need to press the "Release "button on the canister
cover.
NOTE:
• At the beginning of the vacuum packaging in a canister or a vacuum bowl, slightly
press down the cover or on the hose adaptor to ensure no loose of the hose and to
avoid air leaking through the gap between the cover and the canister top rim for a few
seconds.
• To test vacuum, simply tug on the cover. It shall not move;
• Different canisters are available in the market and also from Bigland. The operation
procedure will be a little different. Please refer to the individual manual for the specific
canister.
Marinate Meat with a Marinate Bowl
1.
Take out the hose accessory from inside cover, insert it to canister port on unit and the
center hole of canister cover.
2.
Press Marinate button to start working.The indicator led will be light and the screen
will be show the progress. It will release air automatically after finished vacuum, this is for
1 working cycle, this machine will total working for 5 cycles. It takes about 6 minutes to
finish the process.
3.
When the indicator light crush out, then the screen show the "complete",the marinate
process is completed. Pull off the hose accessory from canister port and canister cover.
NOTE:
• At the beginning of the vacuum packaging in a canister, slightly press down the canis-
ter cover or on the hose adaptor to ensure no loose of the hose and to avoid air leaking
24

Hide quick links:

Tabla de contenido
loading

Tabla de contenido