Titan UR 2300 Instrucciones Para El Uso página 3

SAT/DVB (SAT, DECODER), DVD/BLU RAY
or HTS/AMP(UR 2400 only).
- You terminate the mode by pressing
or by code input interruption of more than 10
seconds.
- If lamp flashes twice code was not accepted
and code input can be started again.
Code search
If the brand of your appliance is not in the list or
none of the codes given fits, we recommend a
code search.
Manual and Automatic code search
or CH/SKIP▼ button about any 1 second so
often until the appliance, e.g. your TV reacts
by power off.
Vivanco GmbH, D-22926 Ahrensburg, E-Mail: [email protected], Helpline: +49 (0) 4102 231135
button
1 Switch on the appli-
ance to be controlled.
Program is running.
2 Press (power) but-
ton and then (mute)
button simultaneously
until a device lamp
(LED) lights
stantly.
3 Press SELECT button
as often until e.g. TV
led is on.
4 Then point the remote
control at the appli-
ance to be controlled.
5 Press the CH/SKIP▲
- You can invert search direction by changing
from button ▲ to ▼ and vice versa.
- If your appliance has switched itself off, you
must switch it on again, e.g. on the appliance or
with the original remote control, to continue
searching.
- When your appliance reacts you can also try
out other buttons, except ▲ or ▼ or
without interrupting the search. If some buttons
do not work properly, simply continue searching
by pressing ▲ or ▼ again.
6 Enable and disable Automatic code search :
Press and hold ▲ or ▼ button until device
lamp (LED) turns off. Then one power on/off
command per code is send out, one after the
other and device led is flashing. Switch to
Manual Code Search again by pressing any
button, except
7 When your appliance reacts correctly, press
(or OK) button, for end of searching and
saving of found code. The lamp (LED) goes
con-
out.
- The last code entered remains stored. The
search stops after approx. 30 seconds of in-
activity or at end of code list.
Code identification
You can read off the 4-digit codes you have set
at any time:
1 Press SELECT button as often until e.g. TV
led is on.
2 Press (power) button and then 1, 2, 3 or 4
button simultaneously depending on the part
or OK.
or OK,
3