Idiomas disponibles
Idiomas disponibles
INSTALLATION OF WP 2000
Install the heater on wall at a distance of 20 cm minimum from the ceiling. (see diagram). The installation height
ranges from to 2,5 m to 3,5 m maximum. The ideal installation is on wall with a 45° inclination and with the heater
placed in a perfect horizontal way. If the appliance is mounted on a tripod or on the wall, the minimum installation
distance must be of 2 meters. Do not place the heater immediately under a power socket.
POSITIONING WP 2000
Adjust the WP 2000 reflector in the direction of the required heating bundle, when installing on a wall. It is usually a
45° inclination related to the horizontal line. The appliance must never be installed on a flammable surface WP 2000
must be placed at a safe distance (clear space) of minimum 2.0 m. from combustible materials such as: cartons,
fabrics, curtains etc. as well as glass walls. If placed in workshops and garages where there are flammable paints and
liquids, WP 2000 must be placed at a minimum distance of 4 m. from the source of danger.
We suggest not to use WP 2000 in particularly dusty and closed areas. This could damage the bulb.
MAINTENANCE AND REPLACEMENT OF THE BULB
To maintain the heating efficiency of your WP 2000, occasionally dust the cover and bulb with a clean brush or
compressed air.
To replace the bulb:
1. Disconnect the heater from the power supply
1. Disconnect the heater from the power supply
2. Loosen and remove the frame fixing screws
3. Remove the frame
4. Remove the cover, which does not have internal fixing points.
5. Remove the bulb by expanding the locking spring and sliding it out.
6. Disconnect the bulb wires from the two (2) terminals.
7. Insert the new bulb, reconnect the wires and fit the locking spring, taking care not to touch the bulb with bare
hands.
8. To close WP 2000, replace the cover, frame and screws.
8
