Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Check that the voltage and frequency of the electricity supply network coincide
with those described in the characteristics plaque. It is essential that the electricity
installation where the appliance is to be installed has an earth connection, as well as the
necessary protection of a thermal magnetic switch and a circuit breaker. Do not connect
other appliances in the same electric socket.
Remove the outside plastic and any remaining adhesive covering the steel.
Installation on a worktop of the owner:
Attached to this manual you will find the holes that should be made on the
worktop.
The gantry must be then fastened down with the bolts provided.
You can switch on the by pressing the start-up switch located on the itself. Said
switch should light up.
RISKS AND USE PRECAUTIONS
The appliance must be only repaired by qualified personnel. Please contact your
distributor and do not attempt to open this appliance.
If the appliance is not going to be used for long periods of time, make sure it is
cleaned and disconnected from the mains electricity supply.
Make sure that external sources do not influence the appliance that may
prejudice its performance (direct sources of cold or similar).
This appliance is made of stainless sheet steel and there are risks of cutting
inherent in its design and to being made of thin sheet steel. Please take extra special care
when handling it and cleaning the same.
The hot s can reach fairly high temperatures (maximum of 48º C in premises at
25º C) and consequently there is a risk of burns.
Do not allow children to handle the appliance under any circumstances.
MAINTENANCE AND CONSERVATION
ANY TECHNICAL MAINTENANCE MUST BE CARRIED OUT BY
YOUR DISTRIBUTOR'S TECHNICAL ASSISTANCE SERVICE.
7
Tabla de contenido
