Tabla de contenido
(EN) Warranty rights
LEDS-C4, S.A. guarantees to the consumer and the user of this product its correct operation and covers any
possible repairs or the supply of parts for this product due to manufacturing defects for 5 years* from the
date of delivery. LEDS-C4, S.A. does not accept liability for any damages arising from incorrect use of this
product. Please note that, in order to make a claim, you will be required to present this guarantee certificate
together with proof of purchase. LEDS-C4, S.A. will completely repair the defects in the product free of charge.
Also, if the product was not repaired to a satisfactory standard or if it was not fit for purpose, the holder of the
guarantee will be entitled to the replacement of the purchased product for another one of the same features,
to a price reduction or to the termination of the contract. *Check warranty conditions at www.leds-c4.com.
Composition: Finishes: plating and/or Epoxy paints and compounds of noble materials. Structure: brass, steel
and cast iron. Other components: alabaster, crystal, fabric shades, wood and leather.
MAINTENANCE: Disconnect the mains voltage before starting any maintenance work. Do not use bulbs with a
higher wattage than stated on the label of the luminaire. When cleaning, use a dry soft cloth to avoid damage.
The use of abrasive products or solvents may harm the finish of the luminaire.
IMPORTANT: 1- The electrical connection of the luminaire should be performed by a qualified electrician. The
internal or external manipulation of the luminaire may reduce its safety. LEDS-C4, S.A. cannot be held liable for
any manipulation carried out by the user. 2- Should the luminaire cable or lead be damaged, it should be
replaced only by the manufacturer or their technical service department, or someone equally qualified, in
order to avoid any risk. 3- Do not install the luminaire on surfaces that are moist, freshly painted or electrically
conductive. 4- All luminaires without special protection against dust or moisture (no IP rating) may be used
indoors, except in bathrooms. 5- Use fastening systems appropriate to the weight of the appliance. 6- Make
sure the connections and cables do not come into contact with the hot parts of the luminaire. 7- Make sure the
installation conductors are not damaged by the fastening screws. 8-Under no circumstances should the
luminaire be covered. 9- The lamps become very hot during operation. Let them cool down for 15 minutes after
switch-o before handling them. 10- Do not lean or hang any objects from the luminaire.
SYMBOLS:
Luminaires not suitable for covering with thermally insulating material.
Surface luminaire not suitable for direct mounting on normally flammable surfaces.
Recessed luminaire not suitable for direct mounting on normally flammable surfaces.
All the luminaires bearing this symbol belong to Class I. The earth wire must be connected to the
terminal marked with the Earth symbol.
All luminaires bearing this symbol are Class II. No metal part of Class II luminaires shall be connected
to the earth connection of the home installation.
All luminaires bearing this symbol are Class III, which means that they operate at very low voltage.
No metal part of Class III luminaires shall be connected to the earth connection of the home installation.
This symbol indicates the minimum distance to be left between the lamp of the luminaire
m
and the object illuminated.
All luminaires bearing this symbol should be installed only with halogen wolfram lamps or metal halide
lamps with their own enclosure.
All luminaires bearing this symbol should be installed with their protective enclosure.
Replace any enclosure that is broken or faulty.
Caution, risk of electric shock.
Do not stare at the light source when in operation.
The crossed bin symbol on the device or on the packaging means that, at the end of its life,
the product will need to be disposed of separate from the rest of residues.
Tabla de contenido
