Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2. Setting the close limit switch
-
Press the
key,
2
the display shows
3. Self learning of the forces
-
Press the
key,
3
the display shows
PLEASE NOTE: On completion of the procedure, it is possible to exit the programming procedure, storing the parameters
set: press and hold the
key for 5 seconds until the segments of the display illuminate one at a time until showing
4. Adjusting the sensitivity (default: 4)
This menu allows the sensitivity of the device, when the door encounters an obstacle, to be increased or decreased.
This parameter is already set to a mid value (4) that should be ideal for the majority of installations.
-
Press the
key,
4
the display shows
Press the
key to save
the settings: the display
4
shows
Press the
key:
2
flashes
Press the
key:
3
flashes - the door opens
Press the key
:
0
flashes
PLEASE NOTE: if this parameter is modified, then on completion of programming, it is
necessary to conduct a complete open/close cycle, during which the control unit automatically
conducts a fresh force training operation (during this cycle, the motor works at maximum force,
so particular attention must be paid).
Press and hold the
+
(the door opens)
-
or
(the door closes)
key to reach the fully
close position
When the door stops, press
the
key to confirm.
Press the
key once more
to continue - the door closes
Select the desired level using the + and – keys
33
When the door reaches the
closed position, wait 2
seconds, then press the
key to save the settings
When the door stops, press the
key to save the settings.
3
The display shows
0
Tabla de contenido
