Cleaning And Maintenance - Rover BE-M 10 Instrucciones Para El Uso

WARNING: Make sure the ventilation grid on the cooling fan is not covered as this will cause overheating.
Once you have finished using the pump and before storing it, you must:
Clean the inside of the pump by pouring clean water or any other compatible liquid through it.
Pull the plug out.
Wait for the motor to cool down to room temperature.
Remove the tube from the hose adapters.
Empty the pump by turning it upside down.
Replace the pump and plug the hose adapters in order to prevent dust or insects entering the pumps during storage. Clingfilm or corks can be used to do this.
N.B.: Before installing a new pump, or if your pump has not been used for any given length of time, check that the drive shaft rotates freely, this will prevent the impeller or the seal on the shaft from jamming .
If there are any obstructions, open up the hydraulic part of the pump and try to rotate the shaft manually in both directions. This work must only be carried out once the plug has been removed from the socket.
MAINTENANCE
During normal operation, the electric pump will not require any maintenance work. The said pump must only be dismantled by specialised, qualified staff who have the requisites provided for by the standards currently in force.
Repair and maintenance work must only be carried out after the pump has been disconnected from the power supply.
MODIFICATIONS AND SPARE PARTS
Unauthorised modifications made to the pump will free the manufacturer of any kind of responsibility. All spare parts used for repair work must be original ROVER POMPE spare parts, and all accessories authorised by the
manufacturer, in order to guarantee the maximum safety of both the machines and the systems they are fitted onto.
TRANSPORTATION
Always use the special accessories necessary for transporting the pump (handle, bracket, trolley)
WARNING: make sure the handle, bracket and trolleys are always well-fastened to the pump.

CLEANING AND MAINTENANCE

When the pump has been used to transfer dirty or corrosive liquids, it must operate for a few minutes pumping clean water only. Use a dry cloth to clean the outside surface of the pump. Protect the pump from damp during
storage, particularly the electric motor.
Empty the remaining liquid out of the pump body completely if there is the risk that the ambient temperature will drop to below 4°C. This is necessary in order to prevent ice from
forming inside the pump.
Do not dispose of this booklet after having read it. Look after it as carefully as you look after your pump.
ELECTRIC PUMPS WITH A BY-PASS
The By-Pass is a manual governor which enables the user to alter the capacity of the electric pump from the maximum value to approximately half this value. As this device must necessarily be installed in
the factory, it cannot be ordered as an accessory.
Adjustment is carried out as follows: if you move the lever to the very left, the pump capacity will be at the very maximum; if you move the lever to the right, the value of the capacity will drop to about half.
The By-Pass valve must be closed during pump priming phase.
MULTIPURPOSE AND NOVAX DISPENSERS
DISPENSERS are supplied preassembled, complete with 5 metres of tubing and gun. The start-up and priming operations are the same as for the electric pumps. The suction pipe must be connected up to the
unused hose adapter of the electric pump. Use of the guns: the gun is supplied with the dispenser, according to customer's choice. The Plastik and Metal models are MANUAL, that is the operator must cut off the
flow. The Automatik gun closes AUTOMATICALLY, meaning that once the container has been filled, the gun will trigger and automatically cut the flow of liquid off. An operator is still needed, however, in order to
check the system functions correctly.
WARNING: when the gun triggers, only the flow will be cut off, while the pump will continue to function. Switch the pump off within 2-3 minutes if no other filling operations are going to be carried out.
 ROVER POMPE snc – 2009/2010 page - 29 -