Hardware Installation - IOGear SharePro GWHD2DKIT Guía De Configuración Rápide

2

Hardware Installation

STEP 1
Turn on both the video source and the display (TV or projector). Make sure that
the input source on your display corresponds to the HDMI port that the transmitter
is connected to.
STEP 2
Insert the transmitter into the HDMI port of your video source device.
Transmitter
2
STEP 3
Use one of the USB charging cables to connect to the micro USB port of the
transmitter to a type USB-A port on the source device to obtain power. In a rare
case that the source device has no USB port, please use a 5V USB power adapter
with a minimum of 500mA output (not included in the package). At this time both
the power LED (blue) and the wireless LED (red) will light up solid and then the
wireless LED (red) will go out and come back on and both will remain solid.
In case the space around the HDMI port is too tight or the position is too awkward
and could cause a connection issue, use the HDMI cable extender or the 90
degree HDMI adapter included in the package to correct this issue or to increase
the spacing.
Transmitter
3