General Operations - Blaupunkt MONTREAL CD34 Manual Del Usuario

General Operations

Turning the power On
Press the PWR button to turn the unit On.
Turning the power Off
Press the PWR button for more than 2 seconds. Display will
revert to clock indication.
Tip
When you turn on the unit, "HELLO" will be displayed then
"WELCOME" will momentarily be displayed before actual
power on.
When you turn off the unit, "SEE YOU" will be displayed then
"GOOD-BYE" will momentarily be displayed before actual
power off.
You can edit these messages. (See "Turn on/off message edit").
Volume Control
Rotate the VOL dial to adjust the volume.
VOL
Volume down Volume up
Muting the sound
Press PWR . The R-ch/L-ch Level Meter flashes.
To restore the previous volume level, press
Mute level can be adjustable. (See " Adjusting the Sound
Characteristics ")
Switching the Display
MENU
Press the to display the temporary indication (initial
setting is clock display) for few seconds. Then automatically
returns to the previous indication.
• Radio mode
Frequency and Clock.
• CD mode
Elapsed time and Clock.
• AUX mode
AUX and Clock.
Setting the Clock
1.
Turn the ignition key to the ON position.
2.
PWR
Press the
3.
Press the MENU
play "CLK SET".
4.
Press the PWR
5.
Use the following buttons and dial to set the clock. (The blink-
ing section can be adjusted.)
PWR
VOL
or
6.
MENU
Press the
ting mode.
Ignition-off Clock Recall
The display will illuminate showing the time and then auto-
matically shut off after 5 seconds.
Press the MENU while the ignition switch is in the " OFF "
position.
PWR
again.
Switching the Source (Selecting auxiliary
input)
You can connect auxiliary equipment (Portable cassette player,
etc) to this radio.(See page 10)
SRC
Each time the
change over as shown below;
RADIO
Note
If the SRC button is pressed when no CD has been loaded
into the unit, The CD mode will skip to the AUX mode.
to turn on the unit.
, then press the or to dis-
to enter the clock adjustment mode.
: To switch Hour/Minute blink
: Adjust the Hour and minute
momentarily to complete the Clock set-
is pressed, the operation source will
CD AUX
Adjusting the Sound Characteristics
1.
Press the AUD to enter the audio adjustment mode, then
press the or to select the desired adjust-
ment item as table below.
2.
Press the or or rotate the VOL dial to adjust
the selected item.
Use the following tables as a guide for adjusting the set-
tings in each item.Adjust within 6 seconds after selecting
the item. After 6 seconds, the unit returns to previous
indication.
VOL
or
Adjustment Range
0
BASS BAS –5
TREBLE TRE –5 0
LOUDNESS LOUD OFF
0
BALANCE BAL L9(Full left)
FADER FAD R9(Full rear) 0
ON VOL 0 50
MUTE 0 20
•A italicized letter is an initial value.
Tips
• ON VOL (Limit volume)
Adjust the volume at the time of power on. You can adjust
with the actual sound.
• MUTE (Mute level)
You can adjust the mute level with the actual sound.
• Settings for BASS, TREBLE, and LOUDNESS can be made
to each of the following modes independently:
FM, AM, CD, AUX.
BAS +5
TRE +5
LOUD ON
BAL R9(Full right)
FAD F9(Full front)
80
80
E-3