Operating Instructions; Remote Control; Optional Installations/ Accessories; Optional Purge Pump - MasterCool MCP Serie Manual De Instalación Y Funcionamiento

OPERATING INSTRUCTIONS

The MCP Series of Coolers has an electronic touch control panel in the
upper right hand corner.
Before turning unit on, ensure unit is plugged in, water supply to pump is
on, and there is correct ventilation, as shown on page 3 of this manual.
Note:
The MCP series coolers is controlled by the 3 buttons on
the front panel of the cooler or with the remote control
On/Off
This button initiates power to the unit. When rst plugged, pressing ON/
OFF and will start the unit in the default setting (pump ON and Fan on
HIGH). After its initial use, the last operating settings (for fan and pump)
will be reinstated when the unit is turned on again.
Pressing this button when the unit is already running will turn both fan and pump off.
After A Power Failure: Once power is restored, the unit will restart in the same settings as before power was lost.
Pump
This button toggles the pump on and off. When the LED is lit, the pump is running.
The pump must be on while operating the fan for the unit to operate as an evaporative cooler, though the unit can be
used in fan mode without the pump, if desired.
Note: For best results turn on the pump for a few minutes to wet the pads
before operating the fan.
Fan
Pressing the fan button cycles the unit from HIGH, to MEDIUM to LOW
speeds and then OFF.
Please Note: There is a two second delay from the pressing of the button
for the fan to engage or change speeds. This applies to the front control
panel and the remote control.

Remote Control

The remote control supplied with this cooler allows you to turn the unit
on or off, control fan speed and initiate the pump. The buttons operate
i n the same manner as those on the front control panel.
The remote control's range is approximately 20 feet within sight
of the cooler. It uses two AA alkaline batteries (included). A wall
mountable holder is also supplied with the remote.

OPTIONAL INSTALLATIONS/ ACCESSORIES

Optional Purge Pump

In addition to the standard water pump to recirculate water
from the reservoir, a purge pump can be installed to evacuate
the contents of the reservoir on a scheduled basis. This helps
reduce bacterial growth and mineral buildup on the media, extend-
ing its life. It also maintains fresher air in the home.
The use of the purge pump saves water and is actually more
economical, than continual bleed. The purge pump kit (P/N
MCP44-PPK) for this unit may be purchased locally or online
at www.championcooler, or by phone at 1.800.643.8341.
Purge Pump
Programming
Indicator lights
.
FAN
Purge Pump Discharge: The water ejected at the time of
purging will be expelled at a high rate of speed, and must
be routed away from the foundation of the home or other
areas where rushing water could do damage.
1. Attach a standard water hose to the over ow drain to
direct the water away from the house.
NOTE: This water is not potable, but can be used for wa-
tering vegetable or ower gardens.
8
Fan Speed Indicator Lights
FAN
HI M ED LO
POWER
PU M
Pump Power Indicator
Unit Power ON/OFF
Pump ON/OFF
Fan Speed (1-3)
ON
PUMP
P