Trial Run - lbx HDB Serie Manual De Usuario

5. Trial run

Make sure the required operating voltage and the power supply's voltage match.

Make sure the socket is earthed.

Add the substance to heat in the testing tube and place it on the work plate.

Plug in the power inlet, and turn on the "POWER" (1) switch.

Set the target temperature with the T º button (4) and adjust it with the knob (2). You shall

see the required temperature on the screen (7)
Set the time, with the timer button (3) otherwise, the machine will work continuously. The

selected time should appear on the timing screen (8)
Press the parameter setting knob (2) to start the heating function.

While the device is on, the heat led (6) will be on (yellow light) and if the timer has been set,

the timer led (5) will also be on.
On the Tº display (7) working temperature shall appear. If the timer has been set, the

adjusted time will show on the time display (8)
If the heat increases and the timer is counting down, the device is working properly.

6. Handling
Place the equipment in a plane and stable surface, leaving at least 100 mm of free space on

each side. Make sure that the surface is adequate for the weight of the equipment.
Add the substance into the testing tube and place it on the work plate.

Plug the appliance, and turn on the "Power" switch.

Wait until the device finishes the initializing process, the real temperature of the device will

appear on the screen (7).
After adjusting temperature and timer (if necessary), press the adjusting knob (2)

The heat (6) and time (5) LEDS shall stay on (yellow)

After use, the device must be turned off using the "Power" button (1) and unplugged.

Make sure the device stays unplugged while is not being used for long periods

7