ESYLUX PROTECTOR Operación Manual página 27

GB OPERATING INSTRUCTIONS
4 • OPERATION AND PROGRAMMING
5.
Save configuration
Save the configuration after each setting made in the menu, otherwise your settings may be lost in the event of a power failure or if the control
centre is reset [Rücksetzen].
6.
Load configuration
Loads the settings most recently saved in menu 5. Save configuration
7. Information
- Shows the software version installed
- Shows the serial number
- Enables software updates via the USB port. Please refer to the "Software update" chapter for further information
5 • OPERATION
Normal operating mode
In normal operating mode, no messages are pending. The control centre is idle. Only the network control LED is on; the collective indicators are off. The display is in normal display mode.
Figure 5: Normal operating mode, normal display mode
Status display mode
[Status] shows a list of pending messages. Navigate with [ ] and [ ] and press OK for further information on the selected message.
You can use the function keys to change the status view to 'fault', 'switch-off' or 'test' to display all current faults, switch-offs or tests.
Figure 6: Alarms status display mode
Alarm
When the alarm is triggered, the control centre buzzer is active, the relevant collective indicator lights up and the display switches to alarms status
display mode. The outputs switch depending on the program settings. The most recent message is displayed in the 3
sight how many messages are pending.
Figure 7: Alarms status display mode
[ESC] switches the display to normal display mode.
If no delay (verification time) is programmed, the programmed alarm type, e.g. FIRE, will be displayed.
Figure 8: Normal display mode, main alarm
line, so you can see at first
rd
27