Prepare The Hood - Broan Allure QS2 Serie Manual Del Instalacion

PREPARE HOOD LOCATION
ROOF CAP
SOFFIT
CABINET
HOOD HOOD HOOD
24" - 30" ABOVE
COOKING SURFACE
1 Determine whether hood will discharge vertically (3¼" x 10"
or 7" Round), or horizontally (3¼" x 10" only). For vertical or
horizontal discharge, run ductwork between the hood loca-
tion and a roof cap or wall cap. For best results, use a mini-
mum number of transitons and elbows.
2 Use diagrams, below, for proper placement of ductwork and
electrical cutout in cabinet or wall. For a non-ducted installa-
tion, DO NOT cut a duct access hole.
HOOD MOUNTING SCREWS (4)
15 /
13 "
(30" hood)
16
15 /
16 "
(36" hood)
16
15 /
19 "
16 (42" hood)
CABINET FRONT
CABINET BOTTOM
5¼"
VERTICAL DUCT
ACCESS HOLE
5"
1¼"
WOOD SHIMS
CENTER
(recessed-bottom
cabinets only)
WOOD SHIMS
(recessed-bottom
cabinets only)
CABINET FRONT
HORIZONTAL DUCT
3¾"
CABINET
5¼"
BOTTOM
13 15 / 16 "
(30" hood)
16 15 / 16 "
(36" hood)
19 15 / 16 "
(42" hood)
HOOD
MOUNTING
SCREWS (4)
®
3¼" X 10" or
7" ROUND DUCT
(For vertical
discharge)
HOUSE WIRING
(Top or Back of hood)
WALL CAP
3¼" X 10" DUCT
(For horizontal discharge)
3¼" X 10"
VERTICAL DUCTING
15 /
13 "
16 (30" hood)
15 /
16 "
16 (36" hood)
15 /
19 "
(42" hood)
16
7½"
5¼"
2"
ELECTRICAL
ACCESS HOLE
(in cabinet bottom)
LINE
3¼" X 10"
HORIZONTAL DUCTING
1 / 8 " ¾"
ACCESS HOLE
5¼"
7½"
13 15 / 16 "
(30" hood)
16 15 / 16 "
(36" hood)
19 15 / 16 "
(42" hood)
ELECTRICAL
CENTER
ACCESS HOLE
LINE
(in wall)
PREPARE HOOD LOCATION
(Continued)
3 Run house wiring between service panel and hood location.

PREPARE THE HOOD

10½"
1½"
1 Remove 7" Round Duct Plate from top of hood. Set duct
plate aside - with mounting screws.
FILTERS
2 Remove tape holding Filters in place. Pull down on filter
tabs or finger holes and lift filters out. Set filters aside.
ALLURE
VERTICAL DUCTING
7" ROUND
DUCT PLATE
®
QS2 SERIES
RANGE HOOD
Page 2
7" ROUND