Adjustment Mode - LaserLine Cubus Manual Del Usuario

Adjustment mode

Take the alignment of the rotary laser into account when
performing adjustment work. Always adjust all the axes.
X axis adjustment
Activate adjustment mode: Switch on the Cubus. Simultaneously
press the ON/OFF button and the auto/slope button until the tilt LED
flashes rapidly.
Switch to the X axis using the tilt button. (LED auto/slope)
Adjustment: Use the positioning buttons to move the laser from its
current position to the height of reference point A2.
Cancel adjustment: Switch the device off.
Save: Pressing the scan button saves the new adjustment settings.
Adjust the Y and Z axes
Activate adjustment mode: Switch on the Cubus. Simultaneously
press the ON/OFF button and the auto/slope button until the tilt LED
flashes rapidly.
Adjustment: Use the positioning buttons to move the laser from its
current position to the height of reference point A2.
Cancel adjustment: Switch the device off.
Save: Pressing the scan button saves the new adjustment settings
To adjust the Z axis, set up the device vertically
and proceed in the same manner as for the
X axis adjustment.
Regularly check the adjustment before
!
use, after transport and after extended
periods of storage. Always make sure
to control all axes.
Cubus / Cubus G
Z
Y
X- / Y- /
Z-Axis
X
23
GB