Installation and Mounting:
Step 1. Remove the (2) Screws on one side of the vehicle (See Item #1 in Figure 1) Note: It is highly recommended that you install one
side of the Citadel at a time to keep the rear glass and spoiler in alignment!
Step 2. Loosen the (2) nuts on one side (See Item #2 in Figure 1).
Step 3. Using light pressure, separate the spoiler from the glass and slide the Citadel bracket into place (See Figure 2). Make sure the nuts
are loose enough that you don't have to force the bracket in place. Note: Make sure the outside edge of the bracket is even with the
outside edge of the glass (See Figure 3).
Step 4. Torque the Screws to 7 NM (62 Inch Lbs) and the nuts to 9 NM (80 Inch Lbs).
Step 5. Repeat steps 1-4 on the opposite side.
Step 6. Attach the harness to the underside of the spoiler using the supplied square adhesive mounting bases and zip ties to the areas
shown (See arrows in Figure 4). Note: Thoroughly clean all locations where the square adhesive mounting bases will be installed
with the supplied alcohol pads before adhering the bases to the vehicle! Allow the alcohol to dry completely before applying the
mounting bases. Make sure the harness is securely attached up and away from the wiper arm or it could become entangled in the
wiper arm.
Step 7. Open the hatch, remove the protective tape from the vehicle's OEM boot and route wiring through the boot as shown in Figure 5.
Note: It will require the use of wire pull lubricant or liquid soap to aid in feeding the wiring through the boot. Pull out the slack from
the wiring making sure there is just enough slack to open and close the hatch and rewrap the boot with appropriate tape to seal the
boot back up.
MATRIX ENABLED APPLICATIONS: The routing of the connectors through the boot/hatch will be very tight. We suggest removing the
grommet and associated wiring from the hatch area as shown in Figure 6. Cut a small opening in the grommet to pass the wiring through.
Pass the connectors through the hatch as shown in Figure 7. Re-route the existing wiring as shown in Figure 8 and reinstall the grommet.
Step 8. Refer to product specific manual to form the proper connections.
Figure 1
Page 2 of 8