E
N
G
L
Specifications
I
S
Frequency range:
H
High Frequency Drivers:
Low Frequency Drivers:
Dimensions: (H x W x D)
rating Voltage
Weight:
power consumption:
power consumption in standby mode:
Specifications are subject to change without notice.
Introduction
Thank you for choosing Denon. Modern flat-panel televisions are wonders of digital video, but leave little room for serious
sound reproduction. The Denon-engineered DHT-T110's accurate, dynamically wide-range sound bridges the gap, with
spacious audio reproduction from Music and Movie modes, including Dolby Digital surround decoding, that bring television
and movie sound to life. DHT-T110's inputs adapt to any television or system arrangement, with wireless Bluetooth® stream-
ing for convenient audio playback from mobile devices. What's more, an ingenious remote control learning solution lets you
continue using your familiar television or cable/satellite remote.
We've worked hard to make DHT-T110 the best performing product of its kind—and just as diligently to ensure it is the
simplest to set up and easiest to use.
You're about to hear just how much you've been missing, but first, please take a few moments to leaf through this brief manual. You
probably think it is not really necessary, and you may well be correct, but doing so will help you get the best from the DHT-T110.
Please save your original shipping carton and packing materials if at all possible. Should you ever need to move or transport
DHT-T110, this is by far the safest way to do so.
Locating DHT-T110
DHT-T110 is designed to support most large flat-panel televisions up to 50" (with a foot base diameter up to 21 1/2 x 12 1/8" (546
x 308 mm)) and 60 lbs (27 kg). The television's base needs to fit entirely within the flat top area of the DHT-T110. There is a "+"
mark on the top center of the cabinet. Use that to get the television base centered on DHT-T110.
You may also place DHT-T110 on a shelf, or furniture, above or below the screen. However, it should be centered left/right with
the screen, and ideally no more than a few inches above or below. DHT-T110 is not suitable for direct on-wall mounting. DHT-
T110 will often sound its best when the DHT-T110's front grille is close to or flush with the front edge of the furniture or shelf on
which it rests (this eliminates unwanted sound reflections).
Not Centered
CaUTION: Allowing the base of your TV to hang over any edge of this speaker system increases the risk of the TV tipping, which may result in injury.
CaUTION: If your TV comes with an anti-tip device, install it according to the manufacturer's instructions and adjust the tether as instructed
after placing the TV on top of the system. Installing an anti-tip device is recommended when using a TV with this product. If your TV did not
come with an anti-tip device, you can get one from most retail TV suppliers.
• If the TV base is too large to fit on top of the system- place the sound system in another location such as on an open shelf under the TV, but keep
it close to your TV so the audio cable will reach. You also could mount your TV on the wall above the system.
• Never place the equipment in an unstable location- The equipment may fall, causing serious personal injury or death. Many injuries,
particularly to children, can be avoided by taking simple precautions.
CaUTION: DO NOT place a CRT type TV on this system. It is not designed for use with this type of TV.
8
DHT-T110E3_140805.indd
8
40 Hz to 20 kHz
1/2" (14 mm) tweeter x 2
2 x 5" (51 x 127 mm) woofer x 2
2 7/8 x 23 7/8 x 14" (71 x 608 x 355 mm)
AC 120 V, 60 Hz
9.5 lbs (4.3 kg)
30 W
0.5 W
Centered
Base is too large
2014/08/05
10:41:19