Fellowes AutoMax 300C Manual Del Usuario página 4

DELAYED START (ON 500C ONLY)
Allows you to delay shredding for 30, 60 or 90 minutes.
DELAYED START
1 2
Open drawer and Close drawer and
press clock icon on
add paper
control panel
**To cancel Delayed Start, press and hold Clock icon for 2 seconds
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator
will remain illuminated and the shredder will not operate for the duration of the recovery time.
Drawer/Bin Door Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.
Remove Paper: When illuminated, see Paper Jam section under Advanced Product Features.
If a critical situation occurs while SmartLock™ is engaged and the shredder drawer
needs to be accessed, follow the steps below.
1 2
Locate the access The service hatch
screw on the back of will begin to rise.
the machine and turn
counter clockwise with the hatch panel
is easily removed
a 6mm allen wrench.
from the top of the
machine.
* Shredder will not run if the hatch is not in place. Always replace the
hatch to resume shredding.
4
Press once for Press twice for
30 minute delay 60 minute delay
(one LED will (two LEDs will
illuminate) illuminate)
In case of a power outage, SmartLock™ will remain engaged.
Once power is restored, shred cycle will automatically resume.
3
To replace the service
hatch, position hatch
panel back on top of
the machine. Hold
panel in place while
turning the allen
wrench clockwise until
you feel resistance.
Press three times for Press four times to
90 minute delay reset clock
(three LEDs will
illuminate)