Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ƒ
ƒ
Never submerge the product in water or other liquids.
ƒ
ƒ
Failure to observe the safety instructions can result in dan-
gerous injuries to persons or damage to the product!
FIRST USE:
The button is on the back of the housing.
Press 1x: 100% mode
Press 2x: 30% mode
Press 3x: Off
When switched on, the lamp can be seamlessly dimmed by
holding the button.
BATTERY REPLACEMENT:
Make sure to switch the lamp off before changing the batteries.
Remove the old batteries. Always change all of the batteries
at the same time. Insert the new batteries as indicated by the
markings in the battery holder.
ATTENTION! Take care to observe the polarity markings (+/-) in
the battery compartment. Otherwise, there may be a risk that the
batteries could become damaged and explode. Ensure that you
do not short-circuit the contacts. Keep the contacts away from
any metal or damp objects when changing the batteries.
Then close the battery compartment again.
Never attempt to recharge non-rechargeable batteries. Never
use new batteries and used batteries together. Use only high-
quality batteries of the same type. Always change all of the bat-
teries at the same time. The use of rechargeable batteries and
high-current batteries is not permitted due to other electrical
characteristics. In the event that this light will not be used for an
extended period of time, ensure that the batteries are removed
to avoid damage. Empty batteries must be removed.
PROPER INTENDED USE:
ƒ
ƒ
The work lamp is used for the illumination of large working
areas, both indoors and out.
ƒ
ƒ
The work lamp is not intended for any other applications.
ƒ
ƒ
Not suitable for household room lighting.
ƒ
ƒ
Suitable for extreme physical conditions.
The lamp shall be set down only on stable and non-slip surfaces
that are as close to horizontal as possible. When placing it on
slight inclines ensure that the feet are arranged such that the
lamp cannot topple over face-down, onto its light-emitting side.
Deutsch |
English
| Français | Español | Português | Svenska | Italiano | Nederlands
HOLDING DEVICE:
If the light is to be fastened with a holding device, ensure that
the holding device is firmly/properly fastened in place in order to
avoid possible damage due to the work lamp falling.
ENVIRONMENTAL INFORMATION | DISPOSAL
The product should not be discarded in the normal household
waste under any circumstances. Dispose of the product via an
authorised disposal centre or your municipal waste disposal
facility. Observe the current applicable regulations. Contact your
waste disposal facility in the event of any doubt. Dispose of all
packaging materials via an environmentally friendly disposal
facility. Used batteries and rechargeable batteries are special
waste and must be disposed of in accordance with national
regulations and not with the normal household waste.
LIABILITY DISCLAIMER:
The information contained within these operating instructions
can be changed without prior notification. ANSMANN accepts no
liability for direct, indirect, incidental or other damage or con-
sequential damage arising though improper handling or through
disregard of the information contained within these operating
instructions. We accept no liability or warranty claims or guaran-
tee claims in the event of incorrect use of the light.
GUARANTEE INFORMATION:
The product has a two year guarantee. The guarantee does not
apply to damage to the device arising through a failure to comply
with the operating instructions.
Subject to technical changes. We assume no liability for printing
errors.
04/2018
Tabla de contenido
