Sanus VMT35 Manual De Instrucciones página 6

2 Mount the Wall Plate
Wood stud
2-1 Locate studs
< 16 mm
(5/8 in.)
2-2 Mark the wall
2-3 Drill pilot holes
2-4 Tighten lag bolts
CAUTION:
Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage:
DO NOT over-tighten the lag bolts [04].
Tighten the lag bolts [04] only until the washers [05] are pulled firmly against the wall plate [01].
[05]
[04]
6
OR
[01]
OR
75 mm
(3 in.)
OR
Verify the center of the stud(s) using an awl, a thin nail, or an edge to
edge stud finder.
CAUTION:
Avoid potential personal injuries and property
damage!
Any material covering the wall must not exceed 16 mm (5/8 in.).
Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
nominal 38 x 89 mm (1¹/2 x 3¹/2 in.)
For assistance in determining wall plate location, see Height Finder
at sanus.com.
Level the wall plate [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage! Pilot
holes MUST be drilled to a depth of 75 mm (3 in.), using a 5.5 mm
(7/32 in.) diameter drill bit.
[05]
[04]
13 mm 5.5 mm
(7/32 in.)
(1/2 in.)
[01]
75 mm
(3 in.)
[01]
6901-002150 <00>