Idiomas disponibles
Idiomas disponibles
SECURE SQUARE STAND TO YOUR COUNTER (OPTIONAL)
For extra security, you can mount Square Stand to your counter by using one of the following methods.
Option 1: Drill mount (recommended)
You need a drill and the following items from the included toolkit: drill bit, thumbscrew, and thumb nut.
Use the included drill bit to make
1
Mark the spot on your counter
2
where you want to secure Square
a hole in your counter.
Stand. Note: Maximum counter
thickness is 1.75 inches (45 mm).
Option 2: Adhesive mount
You need the included adhesive plate.
Using a damp cloth, clean the area
Screw the adhesive plate into
1
2
where you want to secure Square
the base of the stand.
Stand. Wait for the surface to dry
completely.
Line up the hole in the base of
With the thumb nut on the
3
4
Square Stand with the hole in
thumbscrew, carefully insert the
the counter.
screw and tighten from the bottom
until the thumb nut is flush against
your counter.
3
With the base of Square Stand in
Adhere the stand to your counter
4
the locked position, remove the
in the desired position and press
paper backing from the adhesive
down firmly for 30 seconds. Wait
plate. Note: The plate is extremely
30 minutes for the adhesive to set.
adhesive and difficult to remove
once placed.
HOW TO TAKE A PAYMENT
Tap
Dip
In the Square app, tap Charge and wait for a single
In the Square app, tap Charge and wait for a single
green light to appear on Square Reader. Your
green light to appear on Square Reader. You can then
customer can then hold a contactless device or
insert your customer's chip card into the reader. Leave
card near the reader to trigger payment.
it in place until you see four green lights.
Need help?
Get the full guide at square.com/taking-payments.
Swipe
In the Square app, tap Charge. Run your customer's
magnetic-stripe card through the magstripe reader on
Square Stand.
