Mounting The Ap; Wall Or Electrical Box Mounting - 3Com AirConnect 9550 Guia De Incio Rapido

3. Mounting the AP

The AP can be mounted on the following types of surfaces:
•
Wall or electrical box (NEMA enclosure)
•
Table top

Wall or Electrical Box Mounting

To install your AP on a wall or electrical box, use the mounting bracket that comes with the
device. Follow these steps:
1
Following these guidelines, screw the mounting bracket to a wall or electrical box (NEMA
enclosure):
•
The mounting bracket tabs should be pointing upward.
•
If mounting to drywall, use the 4 screws and 4 wall anchors.
•
If mounting to an EU electrical box (60.3mm), use 2 threaded screws and insert into the
holes marked "A" in the diagram shown below.
•
If mounting to a US electrical box (83.3mm), use 2 threaded screws and insert into the
holes marked "B" in the diagram shown below.
2
Connect the Ethernet cable (for power and network connection) to the LAN port on the back
of the AP.
3
To mount the AP onto the mounting bracket, insert the mounting-bracket tabs into the slots
on the back of the AP.
CAUTION: If you are mounting the AP on a wall, you cannot use the slots on the bottom narrow
edge of the device. Instead, you must use the slots on back of the AP.
A
B
5
B
A