Jilong FISHMAN II Serie Manual De Instrucciones página 5

INFLATING THE BOAT
After the inflation adapter is assembled completely, you can inflate the boat by
number sequence. Do not over inflate. After inflating screw the valve cap A in
clockwise direction by hand.
Fill each chamber until it is stiff. Measure the printed ruler to 10cm with the
equipped hard ruler to check the main chamber for proper inflation.
Caution: Do not over inflate or use high-pressure pump. The maximum pressure
for air chamber number
0.10bar(1.45PSI)
Inflating
- Unscrew the valve cap A, assemble the Inflation Adapter with inflating mouth B,
air pressure meter and the air pump.
Caution: Do not over inflate, or use a high-pressure pump!
Deflating
Remove the valve cap A, push down the deflation button C and turn the valve
clockwise direction by 90° until its is locked, release the valve and the air will flow
out. If you want to stop the deflation, push down the deflation button C and turn
it in counter-clockwise direction by 90°. The deflation will stop when the valve is
released.
8 www.jilong.com FBII-14-GB
4
INFLATING THE BOAT
Assembly of the oar
Screwing coupler with front shaft, then insert the rear shaft into the oar locks from
the outside of the boat, join them together by screwing the coupler with rear shaft.
The coupler is then placed on the inside of oar locks to prevent the oar from
sliding into the water.
9 www.jilong.com FBII-14-GB