Maintenance And Lubrication - Super Ego 186000000 Manual De Instrucciones

Position work in vise so that if jam occurs, the wheel
will not tend to move the workpiece in the vise.
Clamp it securely.
Angles should be in an inverted position as shown.
Generally the saw cut most efficiently if the wheel is
cutting the thinnest section at any time.
Using a metallic block
When the cut-off wheel is own and outer diameter is
reduced, insert a metallic block slightly smaller than
the dimension of workpiece under he workpiece. Do
not cut the metallic block.
Recommended cutting capacity
WARNING: Use of tool for grater than recommended
capacities may lead to motor burn-ou and possible
electric shock.
NOTE: Cutting through any cross sectional area
of material thicker than 1/2" tends to load up the
wheel, and this will cause your tool to work harder.
Dimensiones Ø ext. 355 mm x espesor menor de 4,5 mm x Ø del
de la hoja
Seccion transversal
de la pieza a cortar
45 º
90 º
alojamiento 25,4 mm
Máxima capacidad de corte
4 x 1/8" (105 mm)
3-1/2"x 3-1/2" (90 x 90 mm)
3-1/4" x 4" (80 x 100 mm)
5-1/8" (130 mm)
4-3/4" x 4-3/4" (120 x 120 mm)
3-3/4" x 7" (95 x 180 mm)
Brush inspection and replacement
CAUTION: Before inspecting brushes, disconnect
the machine from the power source.
Brush life varies. It depends on the load on the motor.
Check the brushes after the first 50 hours of use for a
new machine or after a new set of brushes has been
installed.
After the first check, examine them after about 10
hours of use until such time that replacement is
necessary.
The brush holders (A), are located on the motor
housing opposite each other. Illustrates one of the
brushes removed for inspection. When the carbon
on either brush is worn to 1/4" in length of it either
spring or shunt wire burned or damaged in any
way, replace both brushes. If the brushes are found
serviceable after removing, reinstall them in the
same position as removed.

Maintenance and lubrication

DNAGER: Never put injury from lubricants on the
blade while it is spinning.
WARNING: To avoid injury from unexpected starting
or electrical shock, unplug the power cord before
working on the saw.
ENGLISH
27