U.S.Robotics USR5411 Guia De Instalacion página 16

My computer does not recognise the Wireless
Possible Solution:
• The Wireless MAXg PC Card may not be fully inserted into the PC card slot. You can
also try installing the Wireless MAXg PC Card into a different PC card slot.
• Your PC card slot may not be configured correctly. To configure your PC card slot,
contact your computer manufacturer.
I am unable to communicate with an Access Point or Wireless Router.
Possible Solution:
Be sure that each Wireless MAXg PC Card that you want to connect to the wireless
network is set to Infrastructure mode within the Configuration Utility. If your Wireless
MAXg PC Cards are not set to Infrastructure mode, they will not be able to communicate
with an Access Point or Wireless Router.
Possible Solution:
Determine the MAC address of the desired wireless router or access point. Using the U.S.
Robotics Configuration utility, check the MAC address and verify that you are connecting
to the correct Wireless Router or Access Point.
Possible Solution:
Ensure that the Configuration Utility is installed for your Wireless MAXg PC Card and that
the Configuration Utility detects your Wireless MAXg PC Card.
Possible Solution:
Ensure that the correct Authentication Mode and encryption key are being used. If you
changed the settings in the configuration of your Wireless Router or Access Point, you
must also change the settings of every Wireless MAXg PC Card attached to this network.
The settings of your Wireless MAXg PC Cards must match the new settings of the Wireless
Router or Access Point. If you are still experiencing difficulties, reset all of your Wireless
Routers or Access Points and wireless network adapters to the default settings and try
again.
I accidentally clicked Cancel during the software installation procedure for the
Wireless MAXg PC Card.
Possible Solution:
Remove and reinsert the Installation CD-ROM into your CD-ROM drive. Follow the
instructions in this guide for installing the software.
The U.S Robotics interface did not begin when I inserted the Installation CD-ROM.
Possible Solution:
Some programs may disable the autorun feature of Windows. Close any open
applications and reinsert the Installation CD-ROM. If the Installation CD-ROM interface
does not run automatically, click Windows Start and then click Run. In the "Run" dialog
box, type D:\setup.exe. If your CD-ROM drive uses a different letter, type that letter in
place of "D."
I inserted the Wireless MAXg PC Card before the Installation CD-ROM.
Possible Solution:
If you inserted the Wireless MAXg PC Card before the Installation CD-ROM, cancel the
installation procedure that is currently running. Insert the Installation CD-ROM, select
12
MAX
g PC Card.