Operation - Central Pneumatic 68066 Manual Del Propietario E Instrucciones De Seguridad

WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with
side shields when operating power tools. Failure to do
so could result in objects being thrown into your eyes
resulting in possible serious injury.
CAUTION:
Do not use in an environment that is dusty or otherwise
contaminated. Using the air compressor in this type of
environment may cause damage to the unit.
APPLICATIONS
Air compressors are utilized in a variety of air system
applications. Match hoses, connectors, air tools, and
accessories to the capabilities of the air compressor.
You may use this tool for purposes listed below:
Operating some air-powered tools.
Inflating tires, air beds, sports equipment, etc.
USING THE AIR COMPRESSOR
See Figure 7.
Ensure tank drain is closed.
Ensure On/Off switch is in the OFF position and air
compressor is unplugged.
If not already installed, attach hose to compressor.
WARNING:
Always ensure the On/Off switch is in the OFF position
and the regulator pressure gauge read zero before
changing air tools or disconnecting the hose from the air
outlet. Failure to do so could result in possible serious
personal injury.
Rotate regulator knob fully clockwise to open air flow.
Connect the power cord to the power supply.
Pull out the red button of the On/Off switch in order to
switch on the compressor.
Rotate pressure regulator knob to desired line
pressure. Turning the knob clockwise increases
air pressure at the outlet; turning counterclockwise
reduces air pressure at the outlet.
Following all safety precautions in this manual and the
Page 12

OPERATION

For technical questions, please call 1-888-866-5797.
WARNING:
Your tool may require more air consumption than this
air compressor is capable of providing. Check the tool
manual to avoid damage to the tool or risk of personal
injury.
manufacturer's instructions in the air tool manual, you
may now proceed to use your air-powered tool.
If using an inflation accessory, control the amount of air
flow with the pressure regulator knob. Turning the knob
fully counterclockwise will completely stop the flow of
air.
NOTE: Always use the minimum amount of pressure
necessary for your application. Using a higher pressure
than needed will drain air from the tank more rapidly
and cause the unit to cycle on more frequently.
When finished, always drain the tank and unplug the
unit. Never leave the unit plugged in and/or running
unattended.
Item 68066