Set Up Your Clover Dock
Step 5
Surface attachment (optional)
Decide whether to screw or adhere the base
plate based on usage and surface.
Usage
Table setup: for higher security, it is highly recommended
to attach the base plate to a surface. If you do not want
to attach the base plate to a surface, remove the tabbed
protectors on the sticky rubber feet and skip to
Wall setup: base plate must be attached to surface.
Surface
Screwing to surface works well for wood or laminate over
wood, drywall, concrete or brick.
Adhering to surface works well for glass, granite, marble or
other hard, smooth surfaces.
Set Up
To set up, start in the position of your main user.
desired surface location, place secured setup from
on top of the base plate. This lets you test positioning before
permanently attaching Clover Dock.
Lift Dock's base from base plate so the plate can be attached
to a surface.
11
Clover Mobile Dock Set Up Guide
STEP
6.
In
STEP 1
If screwing to surface:
Download mounting hole pattern and instructions at
clover.com/setup. In Europe: eu.clover.com/setup.
If adhering to surface (works well for glass, granite, marble
or other hard smooth surfaces):
1.
Clean surface to remove any residual dirt, dust, or oil to prepare
surface for optimum bonding strength.
2.
Remove one of the provided permanent surface adhesives.
3.
Attach sticky side inside one of the designated adhesive areas.
Repeat until all stickies are attached.
4.
Remove all tabbed sticky protectors.
5.
Carefully place base plate in desired position and press firmly on
the 3 adhesive areas for 15-30 seconds.
If adhering, note that adhesive sets immediately and will be very
difficult to reposition once placed. Wait 24 hours for optimal
stability.
It is not recommended to use adhesive for wall mounting. Please
use screws or screws with wall anchors.
Table Setup
For correct fit, place security
screw on the right side.
Set Up Your Clover Dock
Step 5
Wall Setup*
For correct fit, place security
screw on the left side.
English
12