Wiring - Phase Liear PCD160U Manual Del Usario

PCD160U/PMP180U

WIRING

Antenna Connector
WARNING! Never combine (bridge) outputs
for use with 1 speaker.
WARNING! Never ground negative speaker
leads to chassis ground.
CAUTION: Failure to wire exactly as shown
may cause electrical damage to the radio.
CD Changer
Connector
(PMP180U Only)
LF/AVG
White/Black (-)
White (+)
LR/ARG
Violet/Black (-)
Green/Black (-)
Green (+)
5
Gray
Blue
Black
Yellow
+
15A
Red
0.5A
RF/AVD
Gray/Black (-)
Gray (+)
RR/ARD
Violet (+)
Amplifier Wiring
Connect line out for optional
external amplifiers. The red
connector is for the right
and the white connector is
for the left.
Power Antenna
Connect to power antenna
or amplifier. If not used, tape
bare end of wire.
Ground
Connect to ground terminal.
Memory/Battery
Connect to battery or 12 volt
power source that is always
live. The radio will not work
if this wire is not connected.
Accessory/Ignition
Connect to existing radio
wire or radio fuse.
Fuses
When replacing a fuse, make
sure the new fuse is the correct
type (AGC) and amperage.
Using an incorrect fuse could
damage the radio.